|
| I have a John Deere 4440 that I put a ATU 200 (that was ran by a brown box before me), itc globe, and a 2630 display with auto trac and section control in. I also have the correct adapter cable to go from the brown box to the 2630. I have power everywhere as well.
I finished getting the wires ran and everything hooked up tonight, I took tractor outside to play with it and I can get a line and use the line for guidance but never was able to get the atu to snap and auto steer. When I scroll through the 2630 on the Brown Box page in the bottom it says "no fore/aft" and also "no height dimension". So I thought I would try to edit those somehow on the brown box screen but I am not able to edit them. I did input the dimension of the globe position on the tractor into the 2630 on the "Equipment" tab.
Anyone have any experience with this as to why it is not communicating right?
Any help is appreciated.
Thanks Michael | |
|
John Deere ATU200 in 4440 Problems
